2026 Resolutions - Laserfiche WebLink

Home Browse Search

(f) In accordance with Section 40.2-533(L) of the Zoning Ordinance, this Use Permit may be revoked by City Council after conducting a public hearing. The permit may be revoked if Council finds: (i) The Use Permit was obtained or extended by fraud or deception; (ii) The applicant has failed to comply with one or more conditions of approval; (iii) There is a change in conditions affecting the public health, safety, and welfare, since adoption of the Use Permit; or (iv) There are repeated violations of this Ordinance by the holder of the Use Permit related to the development approved by the Use Permit. (g) The proposed development shall be constructed in compliance with use - specific standards for townhouse dwellings and multi -family dwellings in accordance with Sections 40.2-217(D)(1)(d) and 40.2-217(D)(1)(e) of the Zoning Ordinance. (h) The development shall be constructed in compliance with all applicable codes, ordinances and regulations of federal, state and local government, and all required licenses and permits must be obtained and remain in effect during the operation of the development. (i) All taxes/fees associated with the property shall be paid when due, as determined by the City Treasurer. (j) The exterior fagade materials for all elevations (front, rear, and sides) of each unit shall consist of one or more of the following high-quality, durable materials: • Brick veneer or stone; • Cement -based siding (e.g. HardiePlank); • High-quality vinyl siding with a minimum thickness of 0.044 inches, limited to lapped or beaded profiles only; • Cement -fiber board siding (e.g., LP SmartSide or an approved equal). Alternative materials must be approved by the Portsmouth Planning Department prior to construction. (k) All exposed portions of the building foundation walls shall be finished with brick veneer or stone. (1) Roofing materials shall be limited to architectural -grade asphalt shingles with a minimum 25 -year manufacturer warranty, standing seam metal roofing, or copper. Standard three -tab shingles shall not be permitted. (m) The following design elements shall be incorporated to enhance architectural character and reduce uniformity: