Laserfiche WebLink
AN ORDINANCE TO A~LEND THE CODE OF THE CITY OF PORTSMOUTH, VIR- <br />GiNiA, 1973, BY AM~ENDING SECTION 32-24 THEREOF PERTAINING TO <br />REQUIREMENTS FOR FINAL SUBDIVISION PLATS. <br /> <br /> Be it ordained by the Council of the City of Ports- <br />mouth, Virginia: <br /> <br /> 1. That the Code of the City of Portsmouth, Vir- <br />ginia, 1973t be amended by amending Section 33-24 thereqE~~ <br />such amended section to read as follows: <br /> <br />Section 33-24. Final subdivision plat. <br /> <br /> (a) The final subdivision plat shall be prepared <br />by a land surveyor licensed by the Commonwealth of Virginia. <br />It shall be a clearly and legibly drawn reproducible tracing <br />in black India Ink at a scale of one hundred feet to the inch. <br />For subdivisions within the city, the size of the sheet shall <br />be no smaller than 8 1/2 by 13 inches. If several sheets are <br />necessary, they shall all be of the same size, and match points <br />shall be clearly indicated. After the final plat has been ap- <br />proved in accordance with the provisions of this chapterand <br />if such final plat exceeds a maximum size of 17 by 22 inches, <br />the subdivider shall, at his own expense~ cause the final plat <br />to be reduced to a size not to exceed 17 by 22 inches. No final <br />plat~ nor a copy or reduced copy thereof, will be presented for <br />recordation to the office of the Clerk of the Circuit Court if <br />the plat is larger than 17 by 22 inches. Nothing in this sectio~ <br />shall be construed to relieve the subdivider of the requirements <br />in Section 33-22 of this Ordinance. <br /> <br /> (b) The final plat shall contain the certificates <br />and statements required by section 33-3 of this chapter. On <br />the face of the plat, a place shall be provided to receive the <br />signatures, with dates of approval of: (1) The planning di- <br />rector (or the deputy planning director) and (2) the city en- <br />gineer or the assistant city engineer). <br /> <br /> The final plat shall conform to the preliminary <br />layout as approved and shall show the following: <br /> <br />(1) Name and location of subdivision, name <br />and address of record owner and subdivider, <br />date of drawing~ true north point, scale <br />and a location map with a minimum scale of <br />one thousand (1,000) feet to the inch. <br /> <br /> <br />